American Upholstery logo American Upholstery
Call (480) 399-7516 Cart0 Get a Quote
Square Shade Sail, approx. 9′ 4″ × 9′ 4″ drawn to scale over a patio, 2 corners on the house wall and two on steel posts 9′ 4″9′ 4″9′ 4″9′ 4″
Desert SandDrawn to scale · 6′ person for reference

Screen colors are approximate. Request free fabric samples before you order.

Standard shade sail · Made in Phoenix

Square Shade Sail, approx. 9′ 4″ × 9′ 4″

$470 sail only

Four equal sides and four anchors — two on the house and two posts, or four posts. Twist it so two opposite corners sit higher. Covers about 87 ft².

Sizes are approximate, measured D-ring to D-ring; allow about 1″ either way.

  • Commercial 95 HDPE shade cloth — breathable, up to 95% UV block (by color)
  • Welded stainless steel D-ring in every corner
  • Sewn perimeter hem pocket for the stainless cable
  • Curved (catenary) edges cut to tension without wrinkles
  • Limited 90-day warranty
1 Color — Desert Sand
2 Hardware
3 Quantity
Subtotal —

Made to order in Phoenix. Ships nationwide or pick up at our shop. Orders are subject to our Terms of Service and Returns Policy: every sail is made to order, so returns are rarely accepted.

Is this the right size?

Where an approx. 9′ 4″ × 9′ 4″ sail fits.

Our small square. It covers a hot tub, a bistro set or a small landing, and it’s cut from one width of fabric with no seam. Hang it from two points on the house and two posts, or four posts, and twist it so two opposite corners sit higher.

  • A spa or hot tub
  • A table for four
  • A back-door landing or small slab
  • A sandbox or small play area

For this sail, set four anchors in a square about 11′ apart — two on the house and two posts, or four posts — and check that both diagonals measure about 15′ 7″. Keep the low corner at least 7′ off the ground so people can walk under it, and slope the sail so rain runs off. Covers about 87 ft².

Specifications

Sail details.

Size (D-ring to D-ring)Approx. 9′ 4″ × 9′ 4″ (four equal sides, square corners). Allow about 1″ either way.
Perimeter37′ 4″
Shade areaAbout 87 ft² (flat plane; ground shade changes with sun angle and height)
FabricCommercial 95 by GALE Pacific, knitted HDPE, 22 colors, 10-year manufacturer UV warranty
Fabric layoutOne width of 3.0 m (118″) Commercial 95 — no seam
CornersWelded stainless steel D-rings with reinforced corner patches
Hardware kit4 × stainless steel turnbuckles (one per corner); 43 ft stainless steel perimeter cable (perimeter 37.3 ft + 15%); 2 × stainless steel cable clamps
WarrantyLimited 90-day warranty on workmanship (seams, hems, D-ring corners)
SKUAU-SQ0904

Other square size: approx. 18′ 11″ × 18′ 11″ · Square Shade Sails · All 8 standard sails · Custom sail design tool.

Common questions

Questions about this sail.

Is 9′ 4″ the fabric size or the post spacing?
This is a standard sail, so the size is the finished sail, measured D-ring to D-ring. Sizes are approximate, measured D-ring to D-ring; allow about 1″ either way. Your anchors sit farther out than the sail: it’s patterned for about 10″ of turnbuckle at each corner and stretches about 5% as you tension it. For this sail that means: set four anchors in a square about 11′ apart — two on the house and two posts, or four posts — and check that both diagonals measure about 15′ 7″. The planning guide walks through it.
What is in the hardware kit?
Everything that connects the sail to your anchors: 4 × stainless steel turnbuckles (one per corner), 43 ft stainless steel perimeter cable (perimeter 37.3 ft + 15%), 2 × stainless steel cable clamps. The cable is cut long so you have enough to pull it through the hem pocket, wrap it at the corner and clamp it off. Wall pad eyes and posts are not included — see hardware and structure kits.
Should a four-corner sail be twisted?
Yes. Set two opposite corners higher than the other two — a couple of feet or more — so the fabric forms a saddle shape (a hypar). It stiffens the sail, sheds rain and handles wind better than hanging it flat. A flat four-corner sail flaps and can pond water.
Why this size?
They’re the largest sizes that cut from a 3.0 m (118″) wide roll of Commercial 95 with little waste. Every edge takes a 0.5″ hem plus a 2.5″ cable pocket (3″ per edge), and a seam takes 2.5″. The small square, the small equilateral triangle and both rectangles are a single width of fabric with no seam; the large square and the large equilateral triangle are two widths joined by one seam. This one is a single width with no seam. Need a different size? A custom sail is made to any size.
What does the warranty cover?
Every standard sail carries a limited 90-day warranty on our workmanship — seams, hems and the welded D-ring corners — starting on the date it’s delivered or picked up. The Commercial 95 fabric also carries GALE Pacific’s 10-year UV degradation warranty. Damage from wind or storms beyond the sail’s limits, over-tensioning, weak anchors or improper installation isn’t covered. Full terms: Terms of Service.
How long until it ships?
Each sail is cut and sewn to order in Phoenix in the color you pick. Production takes 7–10 business days once material arrives in our shop, then it ships FedEx Ground — the cart shows the exact shipping price and transit time for your address. Need it sooner? Contact us to expedite production and shipping.
Should I take the sail down in a storm?
Yes. Shade sails are not rated for monsoon winds. Loosen the turnbuckles and take the sail down when a storm warning is issued, and before you leave for a long trip in monsoon season.

Start a shade project

Not quite the right size?

A custom sail is built to your finished size or fit to your exact attachment points, and usually tensions better than forcing a standard size to fit.

Phone(480) 399-7516
Emailinfo@americanupholstery.us
Shop4970 N 7th Ave, Phoenix, AZ 85013
Get a shade quote
Call (480) 399-7516Get a quote